Campbell Hausfeld CE5002S Manuel De L'opérateur page 11

Les langues disponibles

Piping

Never use plastic (PVC) pipe for compressed air. Serious injury or death could result.

Any tube, pipe or hose connected to the unit must be able to withstand the temperature generated and

retain the pressure. All pressurized components of the air system must have a pressure rating of 200 PSI or

higher. Minimum recommended pipe size is 3/4 in. Larger diameter pipe is always better. Incorrect selection

and installation of any tube, pipe or hose could result in bursting and injury. Connect piping system to tank

using the same size fitting as the discharge port.

SCFM

100

Chart 1

Installing A Shut-Off Valve

Figure 5

Never install a shut-off valve between the compressor pump and the tank. Personal injury and/or equipment

damage may occur. Never use reducers in discharge piping.

When creating a permanently installed system to distribute compressed air, find the total length of the

system and select pipe size from Chart

where condensation can gather and freeze.

Apply air pressure to the piping installation and make sure all joints are free from leaks BEFORE

underground lines are covered. Before putting the compressor into service, find and repair all leaks in the

piping, fittings and connections.

Minimum Pipe Size For Compressed Air Line

LENGTH OF PIPING SYSTEM

25 FEET

50 FEET

1/2 inch

3/4 inch

1 inch

3/4 inch

1 inch

A shut-off valve should be installed on the discharge port of the

tank to control the air flow out of the tank. The valve should be

located between the tank and the piping system.

Bury underground lines below the frost line and avoid pockets

100 FEET

250 FEET

3/4 inch

1 inch

1-1/4 inch