GRE Premium PP077H Manuel D'instructions page 2

Self-priming swimming pool pump
EN
SAFETY INSTRUCTIONS. READ CAREFULLY
• Our pumps may only be assembled and installed in pools compliant with standards
IEC/HD 60364-7-702 and required national rules.
• The installation should follow standard IEC/HD 60364-7-702 and required national rules
for swimming pools. Consult your local dealer for more information.
• The pump can not be installed in Zone 0 (Z0) or Zone 1 (Z1). To see drawings refer to pa-
ges 61, 62 and 63.
• The electrical installation should be performed by professional staff qualified in electri-
cal installations.
• The apparatus must not be on while the pool is being used.
• Do not operate the apparatus unless it is properly primed.
• NEVER touch the apparatus when it is operating if you are wet or have wet hands.
• When handling the pump, DISCONNECT the power supply.
• Make sure that the ground is dry before touching the electrical equipment.
• Do not install the apparatus where it could become wet, as it may cause electrocution.
• This appliance is not intended for use by persons (including children) with reduced phy-
sical, sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety. Children should be supervised to ensure that they do not
play with the appliance.
• This appliance can be used by children aged from 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning use of the appliance in a safe
way and understand the hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children without supervision.
• If the supply flex of the apparatus is damaged, it should be replaced. Read the instruc-
tions carefully to replace it. If in doubt, contact the technical service.
This mode allows making a correct installation with optimal results of your swimming
pool pump. Carefully read this instruction manual.
Your new pump is a one-stage self-priming, centrifugal pump, designed for use with a
swimming-pool filtering system. It is designed to be used with clean water for tempe-
ratures between 5 ºC and 35 ºC. It is manufactured from high quality materials subject
to strict hydraulic and electrical tests. A correct installation of this pump is assured by
following the instructions from this manual. We decline all responsibility for damages
caused by use different to that explained in this instruction manual.
IMPORTANT
This manual contains basic information on the safety measures to be adopted during
installation and start- up. The fitter and the user must therefore read the instructions be-
fore installation and start-up.
GENERAL SAFETY REGULATIONS
• The machines indicated in this Manual are especially designed for the pre-filtering and
recirculation of water in swimming pools
• Install them in line with the specific instructions for each installation
• All modifications to the pump require prior authorisation from the manufacturer. Origi-
nal spare parts and accessories authorised by the manufacturer ensure greater safety.
The pump manufacturer is exempt from all liability regarding any damage caused by
2