Kobe Range Hoods Brillia Série Manuel D'installation Et Mode D'emploi page 10

Hood Installation
CAUTION: If required to move the cooking
range to install the hood, turn off the power on
an electric range at the main electrical box.
SHUT OFF THE GAS BEFORE MOVING A GAS
RANGE.
1. Using references in Table 1 and measurements on
Page 14, mark the leveling locations point for hood-
mounting bracket on the wall.
2. Secure two mounting screws (provided) to the wall,
leaving an 1/8" space from the wall.
3. Align the hood-mounting bracket to the mounting
screws on the wall and hang hood into place.
4. Secure and tighten the mounting screws.
CAUTION: MAKE SURE HOOD IS SECURE
BEFORE RELEASING.
Wiring to Power Supply
SAFETY WARNING
RISK OF ELECTRICAL SHOCK.
HOOD MUST BE PROPERLY GROUNDED. MAKE
SURE THIS IS
ELECTRICIAN IN
APPLICABLE NATIONAL
ELECTRICAL CODES.
WIRES, SWITCH POWER OFF AT SERVICE PANEL
AND LOCK SERVICE PANEL TO PREVENT POWER
FROM BEING SWITCHED ON ACCIDENTALLY.
5. Connect the electrical wires.
-
Connect three wires (black, white and green) to
house wires and cap with wire connectors.
Connect according to color:
white to white, and green to green as shown on
Figure 4.
-
If necessary to hide the electrical wire
connections, push wires back into the wiring
box. Access the wire connections underneath
the hood. To prevent any damage, make sure
wires do not slip between motor or any moving
parts.
THIS RANGE
DONE BY SPECIALIZED
ACCORDANCE WITH
AND
BEFORE CONNECTING
black to black,
Figure 4
Figure 5
Figure 6
ALL
LOCAL
8