Remote Control - Danby Products ARCTICAIRE ADR556RH Manuel D'utilisation

Remote Control Features
The hand held remote unit allows you to control all
operational aspects of your dehumidifer from the
convenience of your favorite armchair. Here are
some things you should know about operating the
unit with the hand held remote.
Control Buttons
I/O: Power switch (On/Off).
MODE: Selects the required operating mode
(Dehumidifier /Heater /Fan ).
Selects the fan speed settings (HIGH FAN / LOW FAN).
:
Each time the button is pressed will alternate
between HI FAN and LOW FAN speed.
Used to adjust (decrease) setting values.
(See page 6. for details)
Used to adjust (increase) setting values.
(See page 6. for details)
Used to initiate a delayed start "on" time
and/or delayed stop "off" time.
F / C Used to switch temperature readings (LED
º º
readout display) from Celsius to Fahrenheit.
Each time button is pressed will alternate
between both temperature scales.
To operate the hand held remote control will require
two "AAA"(1.5 volt) Alkaline batteries (included ).
Batteries should be replaced when:
a) No signal (beep) is heard from the main unit
when pressing the buttons on the remote control
while attempting to program the main unit.
b) The main unit does not respond to the any of the
commands issued by the remote control unit.
Battery replacement:
1. Open the rear cover on the backside of the
remote control unit in the direction of the arrow.
Continue pulling (gently) until the cover separates
completely from the unit.
2. Replace the (2) batteries "AAA" (1.5 volts) follow-
ing the same orientation (polarity) as depicted
inside the battery chamber.(+/-)
3. Re-install lower cover.
4. If the remote control will not be used for extended
periods of time (vacations etc.), batteries should
be removed.
The remote operates within a range of 7 meters
(23 ft.) from the receiver located inside the main unit.
Any obstruction between the receiver and remote
may cause signal interference, limiting the ability to
program the main unit.
8