Danby Products ARCTICAIRE ADR556RH Manuel D'utilisation page 7

Explanation of key pad functions on the electronic control board.
I/O Button : Each time this button is pressed turns the unit On/Off.
Fan Button: Each time this button is pressed the fan speed
will alternate between HIGH FAN & LOW FAN.
Timer Button: Used to initiate a delayed start "on" time
and/or delayed "off" stop time. Pressing the button while the
unit is off will allow you to set the delayed start "on" timer.
Pressing the button while the unit is on will allow you to set
the delayed stop "off" timer.
This button allows you to decrease the timer length, relative
humidity or temperature settings. Each time the button is
pressed during;
TIMER: the timer value will decrease by 0.5hrs from10
hrs down to 0.5 hrs. then 1.0 hr increments from 24 hrs.
down to 10 hrs.
DRY MODE: the SET RH% value will decrease by 5%.
(adjustable values between 80% ~30%)
HEAT MODE: the temperature value will decrease by
1º Celcius or Fehrenheit. (32ºC/90ºF ~ 18ºC/ 64ºF)
This button allows you to increase the timer length, relative
humidity or temperature settings. Each time the button is
pressed during;
TIMER: the timer value will increase by 0.5hrs up to 10
hrs. then 1.0 hr increments from 10hrs. up to 24hrs.
DRY MODE: the SET RH% value will increase by 5%.
(adjustable values between 30% ~80%)
HEAT MODE: the temperature value will increase by
1º Celcius or Fehrenheit. (18ºC/64ºF~32ºC/90ºF)
3 4
5
1 2
Mode Button: Each time this button is pressed will alternate
between dehumidifier, heat and fan mode. The symbol for the
mode selected will appear in the LED display
LED READOUT: The LED displays the following information:
1. ROOM AIR = Room Ambient RH% or Temperature Conditions
2. SET AIR = The Set Operating RH% or Temperature Value.
3. MODE: = The selected operating mode;
4. FAN SPEED = The selected fan speed.
5. TIMER = The selected delayed start "on"/stop "off" time.
6
DRY FAN
HIGH LOW
0.0
OFF
ON
HEAT
TIMER
LENGTH