Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
Problem
Cause
Very large or
The wrong burner orifice
yellow surface
is installed.
burner flames.
Surface burners
The oven door lock is
light but oven
turned on.
burners do not
light.
The Gas Pressure
Regulator shut off switch
is in the off position.
Oven
Problem
Cause
The oven control
There may be an issue
beeps and displays
with your oven. See the
an information
"Information codes" chart
code.
on page 50.
46 English
Action
Check the burner orifice size.
Contact your installer if you
have the wrong orifice (LP
gas instead of natural gas or
natural gas instead of LP gas).
The display will show the Lock
icon. Hold the oven door open
and press
for 3 seconds.
The oven will beep and the
Lock icon will turn off.
Call a qualified service
technician.
Action
Press OFF/CLEAR, and then
restart the oven.
If the problem persists,
disconnect all power to the
range for at least 30 seconds
and then reconnect the power.
If this does not solve the
problem, call for service.
Problem
Cause
The oven will not
The oven is not
turn on.
completely plugged into
the electrical outlet.
A fuse in your home
may be blown or the
circuit breaker may have
tripped.
The oven
The oven temperature
temperature is too
needs to be adjusted and
hot or cold.
recalibrated.
The oven burner
The oven door lock is
will not shut off.
turned on.
The Sabbath function has
been activated.
Action
Make sure the electrical plug
is fully inserted into a live,
properly grounded outlet.
Replace the fuse or reset the
circuit breaker.
See page 32.
The display will show the Lock
icon. Hold the oven door open
and press
for 3 seconds.
The oven will beep and the
Lock icon will turn off.
SAb and the time of day will
show in the display. All other
controls and signals will be
deactivated. To turn off the
oven only, press OFF/CLEAR.
To cancel the Sabbath function
and reactivate the controls and
signals, press and hold Bake and
Number 1 simultaneously for
3 seconds.
Publicité
