Télécharger Imprimer la page

Kenmore ELITE HE3t Manuel Du Propriétaire Et Instructions D'installation page 12

Publicité

Les langues disponibles

Les langues disponibles

WASHER USE
WASH
CYCLES
STATUS
ES IMAm I
CUSTOM
I_,!_i/!;;,,_,/I H_
MODIFIERS
A;_ _,,_r
_ O
PROGRAM
HEAVY
NORMAL
/
@
0AS°A, O
(;i;>
D_
_
@
Aue I_,,,,Ce., a
¢:/
H
_
D
DELAY
OPTIONS
o
EXTRA
HOT I COLD
® HIGH
_..e_
®HEAVY
HOT/COLD
MEDIUM
RI
0
0 NORMAL
S_I •
RINSE & SPIN
WHITEST
SANITARY
• LIGHT
PREWASH
WARM
/ WARM
• LOW
C_i;sC[A O
_eb
WHITES
/_
_
_
® WARM/COLD
oEXTRALOW
C)
_ttJ:
)0
DRAIN&SPIN
_
_/
p_ss _. io,) ?
)0,1 0L:K= •Sl¢O
)S _ICCa
SOIL LEVEL
EXTENDED SPIN
® COLD / COLD
@ NO SPIN
ur_t eKe N I_lt
HANDWASH/
END of CYCLE
WATER TEMP
SPIN SPEED
LJNI OC_ rJOOR
2ND RINSE
NORMAL RINSE
0
RINSE
OR_ONR
Fire Hazard
Never place items in the washer that are dampened
with gasoline
or other flammable
fluids.
No washer can completely
remove oil.
Do not dry anything
that has ever had any type of oil on
it (including cooking oils).
Doing so can result in death, explosion,
or fire.
WARNING: To reduce the risk of fire, electric shock, or injury to
persons, read the IMPORTANT SAFETY INSTRUCTIONS before
operating this appliance.
The following is a guide to using your washer. Please refer to
other sections of this manual for more detailed information.
Do not store laundry additives on the top surface of this washer.
Vibration is normal during operation.
Use only High Efficiency detergents. The package for this type of
detergent will be marked "HE" or "High Efficiency." This wash
system, along with less water, will create too much sudsing with a
regular non-HE detergent. Using regular detergent will likely result in
washer errors, longer cycle times and reduced rinsing performance.
If may also result in component failures and noticeable mold or
mildew. HE detergents are made to produce the right amount of
suds for the Best performance. Follow the manufacturer's
instructions to determine the amount of detergent to use.
Use only "HE" High Efficiency detergent.
First Wash Cycle Without Laundry
Before washing clothes for the first time, choose the Normal/
Casual cycle and run it without clothes. Use _/2 the manufacturer's
recommended
amount of powdered or liquid High Efficiency (HE)
detergent for a medium size load. This initial cycle serves to
ensure the interior is clean before washing clothes.
1. To load the washer
Open the washer door by pulling on the handle. Sort laundry
according to color and type of fabric. Place a load of sorted
clothes in the washer. Do not overload washer. Overloading
can cause poor cleaning.
The washer can be fully loaded, but not tightly packed.
Washer door should close easily.
Mix large and small items. Avoid washing a single item.
Load evenly.
Wash small items, such as infant socks, in mesh garment
bags. It is a recommended
that more than one garment
bag be used and that each garment bag be filled with
equal amounts of material.
When unloading garments, occasionally check under the
gray colored seal at the front of the tub for small items.
2. Close the washer door by pushing it firmly until the lock
clicks. The washer door will remain locked during the wash
cycle.
NOTE: After any wash cycle is completed,
the door must be
opened and then closed before a new cycle can begin. The
door can be opened only if PAUSE/CANCEL is selected while
the ADD A GARMENT light is glowing or if the cycle has been
canceled. See "To cancel a cycle" in "Changing Cycles,
Options and Modifiers" section.
3. Open the dispenser drawer and add laundry additives to the
detergent, bleach, or fabric softener compartments.
Close
drawer slowly to avoid spills. See "Using the Dispenser."
4. Turn on the washer by selecting one of the WASH CYCLES.
The indicator light for the selected cycle will glow. When
selecting a Wash Cycle, the preset options, Water Temp, Spin
Speed, and Soil Level for the selected cycle will glow. The
display shows the estimated time remaining. The preset
settings provide the recommended
fabric care for the
selected cycle. See "Cycles."
5. Select the desired OPTIONS. Not all Options are available
with all cycles. See "Options."
6. Select the desired MODIFIERS. Not all Modifiers are available
with all Cycles and Options. See "Modifiers."
12

Publicité

loading