Qilive Q.3603 Manuel D'utilisation page 5

4.2. ASSEMBLING THE SEAT PLATE AND ARMRESTS
1. Turn the seat upside down.
2. Line up the screw holes on the chair with the seat plate. Make sure the arrow on
the seat plate points to the front of the seat.
3. Put the four washers and four spring washers onto the four seat plate screws (the
shorter screws-M8X20mm) and insert into screw holes. Use Allen key to partially
tighten the screws in place. Once all screws are in place, firmly tighten them.
7
6
Note: The washer is a disc which is inserted between the screw and the part to be
tightened. It is designed to prevent the screws from loosening.
Caution: Do not operate the seat height adjustment lever before the chair is fully
assembled, as you could injure yourself!
4.3. ASSEMBLING THE CHAIR ONTO THE BASE
1. Insert the gas spring into the central hole of the seat plate installed under the seat.
2. Sit on the seat to firmly secure the gas spring cover to the chair.
4.4. ASSEMBLING THE BACKREST
1. Place the backrest and seat together to form the chair, and then put the chair on
its side.
2. Line up the screw holes on the angle regulator plate with those on the chair.
3. Put the two back screws (the longer screws-M8x25mm) into the screw holes. Use
Allen key to partially tighten the screws in place. Once all screws are in place,
firmly tighten them.
5
5
14
15
13
EN