Durant E4148793 Mode D'emploi page 6

Programming
• To enter Programming mode, press and hold PGM for 3 seconds.
The display counts down 3..2..1.
Main menu
Type menu
Reset Mode menu
Inhibit menu
Auto Reset menu
P1 Relay Type menu
P1 Relay Safe State menu
LCD Backlight menu
Exit Programming mode
• Press Digit 1 to cycle through the
menus, or PGM to exit Programming
mode.
• Press SEL to select a menu, then
Digit 1 to cycle through the options.
• Press SEL to select an option, or
PGM to exit the menu without
change.
• Press the Digit buttons to adjust a
numerical setting, eg. pulse time.
• Press SEL to accept the setting, or
PGM to exit the setting without
change.
• Press PGM (up to four times) to exit
Programming mode.
If the Type or Reset Mode are
changed the new configuration will
not be fully effective until after exit
from Program mode, AND THEN
AFTER a Reset.
Reset Mode
See page 3.
Inhibit
See page 2.
Auto Reset
See page 3.
Relay
See page 5.
* Auto Reset On and Relay Latched
cannot be set together.
LCD Backlight:
can be on, off, or turn on for 30
seconds when a button is pressed.
6
Type
Counter menu
Timer menu
Main menu
Reset Mode
Reset to Zero
Reset to P1
Main menu
Inhibit
Programming
Programming and Presets
All buttons
Main menu
Auto Reset
Auto Reset on *
Auto Reset off
Main menu
P1 Relay Type
Pulsed ----------
Latched *
Main menu
Pulsed
P1 Relay Safe State
Current state
Normal state
Main menu
LCD Backlight
On
Off
Delay
Main menu