Publicité
Les langues disponibles
Les langues disponibles
Operation instructions
1.
Turn the thermostat switch to the minimal value, at the same time turn the
heat select switch to the "O" position (see picture).
2.
Plug in the appliance, and turn the thermostat switch to the maximum
position. Then turn the heat select switch to choose air or warm air and the
temperature of warm air as below. While working the indicator light will be
on.
2.1 Turn the heat select switch to " " position, the heater blows cool air.
2.2 Turn the heat select switch to "I" position, the heater blows warm air,
working at 1000W.
2.3 Turn the heat select switch to "II" position, the heater blows warm
air, working at 2000W.
2.4 Turn the heat select switch to "O" position, the heater stops working,
the indicator light will be off.
3.
Adjust the thermostat switch to suitable position for desired temperature
setting.
3.1 Check if the thermostat switch is on the maximum position.
3.2 When you feel the room temperature comfortable, turn the
thermostat switch anti-clockwise slowly to the minimal position until the
appliance stops working. Then the thermostat switch will keep the room
temperature at the desired temperature automatically.
You can also turn the thermostat switch anti-clockwise to the minimum
position or turn the thermostat switch clockwise to maximum position to
make the temperature lower or higher.
The heater is fitted with an automatic cut out in the event that it overheats. If
this activates, turn the heater to the off position and un plug. Allow the heater to
cool and remove anything restricting the airflow before using the heater again.
If the automatic cut out operates repeatedly contact a qualified electrician for
advice.
NOTES
● The power indication light will be on if the temperature is below the setting
of the thermostat.
● For maximum benefit, close windows and doors.
● Do not cover the ventilation holes as this will cause overheating and will
activate the cut out.
4
Publicité
