Hitachi Koki Tanaka TBC-225 Mode D'emploi page 8

Cover throttle wire and stop cords together with
protective tube provided up to air cleaner cover.
(Fig. 7)
Installation of blade guard (Fig. 8, 9, 10, 11)
Install the blade guard as shown in Fig. 8, 9, 10, 11.
8
Fig. 7
Fig. 8
Fig. 9
Fig. 10
NOTE
If your unit has guard location label on drive shaft
tube, follow the indication.
CAUTION
● Do not attempt to install metal blade on the
curved shaft trimmer. It is very dangerous.
● Some blade guards are equipped with sharp
line limiters. Be careful with handling it.
Installation of cutting blade (Fig. 12)
(If so equipped)
When installing a cutting blade, make sure that there
are no cracks or any damage to it and that the cutting
edges are facing the correct direction.
11
12
10
13
NOTE
○ When installing cutter holder cap (10), be sure to
set concave side upward.
Insert the allen wrench (11) into the hole of the
angle transmission in order to lock the cutter
holder (12). Please note that the cutter fi xing bolt
or nut (13) has left-handed threads, (clockwise to
loosen/counter-clockwise to tighten). Tighten the
fi xing bolt or nut with the box wrench.
○ If your unit is of a nut securing type and equipped
with a cotter pin, the blade must be retained with
a new cotter pin (14) each time installed. (Fig.
13)
Fig. 11
14
Fig. 12