AVer MD120UI Mode D'emploi page 14

Remote Control
 To open the OSD menu, press and hold Menu
 To disable remote control, open the OSD menu or the web interface, go to System > Camera
Selector > Disable Remote.
 To resume remote control, open the web interface, go to System > Camera Selector > All
Channel or assign a number (1, 2, 3, 4) to your camera.
1
HOME SNAP
REC
2
3
4
5
MIC
PRIVACY SPEAKER
6
X
7
Model: LY033
AAA batteries (x2)
8
Name
9
1. Power
10
2. Home
11
3. Number Pad
12
4. Preset
13
14
15
16
17
5. Zoom +/-
6. MIC
7. Camera
Select
8. Remote
Control LED
9. Menu
10. Snap
11. Rec
12. Reset
13. Direction
14. Volume +/-
15. Enter
for 3 seconds.
Function
Short press to turn on/off Standby Mode.
Move the camera to the Home position.
 Press buttons 0~9 to move the camera to the
pre-configure preset positions.
 Use the buttons to set up preset positions 0~9.
Use the Preset, Number and Direction Buttons to set
up preset positions:
1. Use the Direction Buttons to navigate a position.
Optionally use the "Zoom +" or "Zoom -" buttons to
zoom in/out the image.
2. Press and hold Preset, then press the Number
Buttons (0~9) to save this preset position.
Press to zoom in or zoom out the images.
Press to mute the microphone. Press again to unmute.
Select a camera to operate. Specify a number in the
OSD menu: System > Camera Selector.
When pressing the buttons on the remote control, the
LED will light red.
Press and hold for 3 seconds to open the OSD menu.
Edit this setting in the OSD menu: System > Trigger
OSD.
N/A
N/A
Use the Reset and Number Buttons to cancel a
pre-configured preset position. Press and hold Reset,
then press the Number Buttons (0~9).
Use the Direction Buttons to navigate the live view.
N/A
When camera is on: Press Enter to adjust focus once.
When accessing the OSD menu: Press Enter to
confirm the selection or make a selection.
6