Publicité
Les langues disponibles
Les langues disponibles
DOOR
REVERSAL
1
Rubber cover
2
Screws
3
Decorative cover
4
Screws
5
Top hinge
6
Decorative nail
7
Screws
8
Lower hinge
9
Cabinet leg
10
Extrusion-board
of lamp switch
Screws
11
12
Decorative nail
1. Close the door and take out rubber cover (1), unscrew two screws (2) and remove
decorative cover (3). (Fig.1)
2. Unscrew screws (4) and take out top hinge (5), then remove the door. (Fig. 2)
3. Put door safety, unscrew decorative nail (12) and take out 2 screws (11) at bottom,
pull out extrusion-board of lamp switch (10) and fix it at top of door. Block holes at
bottom of door with spare decorative nail. (Fig. 5)
4. Pull out decorative nail (6) from left top of cabinet. (Fig.3)
5. Unscrew 3 screws (7) from right bottom of cabinet and remove lower hinge (8). (Fig.4)
6. Pull out cabinet leg (9) from left bottom of cabinet and fix it onto right bottom of cabinet. (Fig.4)
7. Fix the lower hinge (8) onto left bottom of cabinet with screws (7). (Fig. 4)
8. The door revolves 180 degrees, put lower door axis to aim at lower hinge (8) and install the door
onto lower hinge (8), then close the door carefully. (Fig.5)
9. Fix top hinge (5) onto left top of cabinet with screws (4), adjust door and install decorative cover (3)
and rubber cover (1). (Fig.6)
10. Block 3 screw holes at right top of cabinet with spare decorative nail.
INSTALLATION INSTRUCTIONS
5
Publicité
