Télécharger Imprimer la page

Danby Designer DWC123BLSDD Guide D'utilisation Et Soins De Propriètaire page 5

Publicité

Les langues disponibles

Les langues disponibles

SETTING THE
TEMPERATURE
• To switch the display between the Fahrenheit (°F) and Celsius (°C) scale, depress the increase and decrease
temperature control buttons simultaneously for approximately five (5) seconds.
• The temperature range can be set as low as 39°F (4°C) or as high as 64°F (18°C) to suit your specific wine
storage requirements. Each depression of the increase or decrease temperature buttons will allow you to adjust
the temperature in 1° increments within the aforementioned range.
WINE STORAGE
To achieve the maximum storage capacity of 45 (750mL) bottles,
follow these stocking instructions:
1) Stock the top 5 full width shelves with 7 bottles per shelf,
positioned as in Fig. A.
2) Stock the bottom 2 half width shelves with 5 bottles per shelf,
positioned as in Fig. B. This will give you a max. capacity of 45
bottles.
SHELF
INSTRUCTIONS
To remove a rack from its locked position, tilt the rack as shown in Fig. C and
pull outward. To re-install, ensure the rack is resting securely on the support
brackets and push the rack inward until it locks into place.
OPERATING INSTRUCTIONS (cont'd)
IMPORTANT: In the event of a power failure, wait 3 to 5 minutes before restarting.
IMPORTANT: Store wine in sealed bottles only.
IMPORTANT: Do not cover racks with aluminum foil or any other material that will
prevent adequate air circulation within the cabinet.
Fig. B
4
Fig. A
Fig. C

Publicité

loading