Bartec CAK-PH-A Consignes D'installation page 7

 Push the grounding braid back. Use the screwdriver to form an
eyelet. Be careful not to damage the internal insulation jacket.
 Bend the trace heater and pull the heating element out of the
grounding braid.
 Twist the grounding braid in order to form a pigtail.
21-59CZ-7D0002
7
8
9
Notice Technical data subject to change without notice.
No claims for damage arising from alternations, errors or misprints shall be allowed.
 Push the green/yellow tube onto the twisted grounding braid.
 Remove 4 1/2" (115 mm) of the internal insulation jacket.
10
11
Page 5 / 21