Publicité
2 Mount the Wall Plate
Wood stud
2-1 Locate studs
41 - 61 cm
(16 - 24 in.)
2-2 Mark the wall
2-3 Drill pilot holes
2-4 Tighten lag bolts
[06]
[19]
[18]
6901-002143 <02>
< 16 mm
(5/8 in.)
[01]
Verify the center of the stud(s) using an awl, a thin nail, or an edge to
edge stud fi nder.
CAUTION:
Avoid potential personal injuries and property
damage!
Any material covering the wall must not exceed 16 mm (5/8 in.).
Minimum wood stud size: common 51 x 102 mm (2 x 4 in.)
nominal 38 x 89 mm (1½ x 3½ in.).
Minimum horizontal space between fasteners: 40.6 cm (16 in.).
For assistance in determining wall plate location, see Height Finder at
sanus.com.
Level the wall plate template [01] and mark the hole locations.
CAUTION:
Avoid potential injuries or property damage! Pilot
holes MUST be drilled to a depth of 75 mm (3 in.), using a 5.5 mm
(7/32 in.) diameter drill bit.
75 mm
(3 in.)
CAUTION:
Improper use could reduce the holding power of the
lag bolt. To avoid potential injuries or property damage
DO NOT over-tighten the lag bolts [18].
Tighten the lag bolts [18] only until the washers [19] are pulled
fi rmly against the wall plate [06].
13 mm
5.5 mm
(1/2 in.)
(7/32 in.)
7
Publicité
