CASO DESIGN WineSafe 12 black Manuel D'instructions page 34

Your device is not cold enough
or it does not reach the
adjusted temperature:
The light does not work.
Vibrations.
The wine refrigerator seems to
make to much noise
The door will not
properly.
LED could not display.
LED display error - Lo
Buttons are not functional.
Compressor will not start
Compressor re-start
Dew on the surface
cabinet：
Liquid sound
Condensation formed inside
the cabinet
Error code E2
Attention
► If you are unable to solve the problem with the steps shown above, please contact
Customer Service.
Check the temperature control setting.
External environment may require a higher setting.
The door is open too often. The door is not closed completely.
The door seal does not seal properly.
The wine refrigerator does not have the correct clearance.
Defrost the device.
Check the service center.
Check to assure that the wine refrigerator is level.
The wine refrigerator is not level.Check the fan.
close The wine refrigerator is not level.The door is reversed and not
properly installed.The seal is weak. The shaves out of position.
Main control board does not work.PCB Problem. There is some
problem with the plug.
Weak quality of display.Temperature point is out off. Check the
service center.
Temperature controller panel is damaged.
Room temperature is lower than desired temperature.
Compressor will stop working when cooling system in the
cabinet reaches presetting temperature, and re-start working
until the desired temperature is achieved. Allow a minimum 5
minute interval before re-starting.
of The surface of wine cabinet especially the glass door appear
some frost if item in a damp room. This is due to the moisture
in the air coming into contact with the cabinet. Please wipe it
away with dry cloth.
（1）、The sound of compressor when starts or stops working
（2）、The flowing sound of refrigerant in the refrigeration
system
（3）、The evaporating sound of refrigerant in the evaporator
Under the environment with high level of humidity or the door
of wine cabinet has been left open for a long period or
opened frequently, wipe off the door and walls and leave the
door closed as long as possible.
Desired temperature is not reached.If necessary defrost the
device (Please follow the hints for manual defrosting in chapter
cleaning).
34