Publicité
Les langues disponibles
Les langues disponibles
PRODUCT STRUCTURE
PRODUCT ASSEMBLY
Remove all small parts from the box.
Base Assembly
1. Remove the Neck Fixing Bolt and Knob from the top of the Pipe.
2. Loosen and remove the Base Locking Screw from the bottom of
the Pipe.
3. Fit the Pipe into the recess in the top side of the Base; and while
holding it, turn it over to access the bottom side.
4. Align the Base Locking Screw against the hole as shown. Tighten
1. Oscillation Knob
2. On/Off/Speed Dial (0/I/II/III)
3. Tilt Adjustment Screw
4. Neck Fixing Bolt
5. Locating Screw
6. Neck Fixing Knob
7. Top of Pipe
8. Pipe
9. Base
10. Base Locking Screw
11. Carry Handle
4
Publicité
