Atco ROYALE 20E I/C Mode D'emploi page 18

All manuals and user guides at all-guides.com
EURO • Printed in England • GB • F016 L69 838 • CLUB/ROYALE • OSW 08/01
CLUB/ROYALE - Buch Seite 6 Dienstag, 7. August 2001 2:41 14
The following table gives checks and actions that you can perform if your machine does not operate correctly.
If these do not identify/remedy the problem, contact your service agent.
Warning: Switch off, remove spark plug cap before investigating fault.
Symptom Possible Cause
Mower leaves a ragged Cutter not correctly adjusted
finish
Engine will not start Engine is flooded
Spark plug lead not connected
Spark plug dirty
no oil
Engine stops No petrol
Engine speed too low for conditions
Cutting cylinder obstructed
Engine does not stop
Cutting cylinder does not Incorrect adjustment
rotate
Land drive does not Incorrect adjustment/cable damaged
engage
Excessive vibration/noise Blade(s) or/and cylinder bearing damaged
Engine fault
18 • F016 L69 838 • TMS • 11.07.01
Fault Finding
Remedy
Adjust the cutter
Leave for 10 – 15 minutes
Reconnect
See engine maintenance manual
add oil
Refill tank
Move throttle
Turn off engine and clear
obstruction
Throttle cable not correctly
adjusted. Stop engine by removing
spark plug lead and refer to the
engine maintenance manual.
Contact an ATCO Approved
Service Agent
Contact an ATCO Approved
Service Agent
Contact an ATCO Approved
Service Agent
See engine maintenance manual
English - 6