RealFlame C9640LP Ventura Mode D'emploi page 17

GAS COMPONENT CONNECTION CHECKS
GAS C
If the burner will not light or stay lit, please perform the following checks.
1. Make sure the electrode wire is completely and correctly connected.
Back of
Electronic
Ignition
2. Make sure that the igniter housing is unobstructed.
Clear any debris on top of the igniter housing and make sure there is no debris
between the igniter pin, thermocouple and the burner tube.
Do not cover
housing
Igniter
Housing
Burner
Tube
CORRECT INCORRECT
17