Publicité
Les langues disponibles
Les langues disponibles
Preparing tapes for editing
Recording editing titles (characters
and symbols)
Characters and symbols can be superimposed onto
the video signals (black burst signals) and recorded
for about 7 seconds after the start of 1ST EDIT, but
this can be done only in the 525i mode.
Recording the editing titles, editing dates, equipment
numbers and other such information makes it easier
to do post-editing work and conduct searches at a
later date.
1
Align the cursor with setup menu item No.379
(1ST-E TITLE), and press the STILL button to
display the character input screen.
2
Press the SHIFT button.
The cursor now flashes at the position where the
characters can be input.
3
While holding the SHIFT button down, select a
character by pressing the "+" or "–" button.
Characters:
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
0 1 2 3 4 5 6 7 8 9 , . : ; ? ! /
4
While holding the SHIFT button down, move the
character input position by pressing the "FF" or
"REW" button.
5
3
4
Repeat steps
and
Present position where
IN point is registered
23:59:37:00
Title recording:
Approx. 7 sec.
' ( ) + – ± ¢ =
to input more characters.
1ST EDIT TC setting
23 sec.
1ST EDIT recording
6
Upon completion of the character input, release the
SHIFT button, and press the STILL button to exit
the character input screen.
7
Select ON as the setup menu item No.380 (1ST-E
DISP) setting.
8
Proceed with 1ST EDIT.
00:00:00:00
00:00:03:00
9 sec.
Return
First assemble editing
54
Direction of tape travel
Publicité
