Publicité
Les langues disponibles
Les langues disponibles
HOW INSTALL JOLLY ONE WITH ELECTROBRAKE
HOW INSTALL JOLLY ONE WITH ELECTROBRAKE
IMPORTANT: Before install JOLLY ONE check that the shutter is correctly balanced by its screws mounted on the shaft. Verify it manually by opening and closing the shutter.
IMPORTANT: Before install JOLLY ONE check that the shutter is correctly balanced by its screws mounted on the shaft. Verify it manually by opening and closing the shutter.
Spring housing
Shaft
=
After have choosen JOLLY ONE according to the dimensions of the shutter, verify the diameter
of the spring housing and of the shaft, because they must have the same diameter of the
choosen motor.
If they're different use the required adaptor:
ACJ9055 SPRING HOUSING ADAPTER Ø 200-220
ACJ9040 SHAFT ADAPTER Ø 42/60
ACJ9050 SHAFT ADAPTER Ø 48/60
A - Make the holes on the shaft as indicated on the rising above draw (see pict.1). Note: In
case it is difficult to drill through the shaft, install the motor as per pic. 3 by drilling a
Ø12 mm not pass-through hole at 62 mm from the center of the shaft.
Open the motor and mount it as indicated of continuation.
B - Open the pulley unscrewing the 2 screws (1).
C - Mount JOLLY ONE on the shaft and position the motor up and the limit switch down (see
pict. 3). Fix JOLLY ONE on the shaft using the fixing flange and its screws (2) and (3)
alternatively, (2) and (5) in case the installation is not done with a go-through hole.
D - Reassemble the pulley and re-screw its screws (1).
E - On the last section of the shutters make a hole Ø 12 mm / 0,4 in which allows to fix the
shutter to the pulley of the JOLLY ONE using the proper screws (4).
F - Insert the electrical cable and the releasing cable in the holes on the shaft (see pict. 3)
and execute the electrical connections.
Hole Ø 12/0,4 (VERTICALLY)(entry for the release cable)
Electrobrake
=
188/7,4
62 / 2,4
Hole Ø 12/0,4 NOT PASS-THROUGH HOLE (FRONT)
Hole Ø 12/0,4 (entry of electric cable)
250 / 9,85
35 / 1,38
Ø 12/0,4 (FRONT) pass-through hole
450 / 17,7
IMPORTANT
Respect the radius of the curve (at least 15 cm / 5,9 in)
=
200/8
23
Hole Ø 12/0,4 (VERTICALLY)(entry for the release cable)
Hole Ø 12/0,4 (FRONT) (entry of electric cable)
=
1
1
Electric Cable
Release Knob
PASS-THROUGH HOLE
1
Measurements in mm/in
2
1
4
2
3
1
2
NOT PASS-THROUGH HOLE
5
3
Measurements in mm/in
G
B
Publicité
