Safety Instructions - Electrolux WS 16 Mode D'emploi

official After Sales Service, because it
requires special tools.
The manufacturer and retailers do not
accept responsibility for any damage

SAFETY INSTRUCTIONS

WARNING!
Before connecting the appliance
compare the power data (voltage
and frequency) indicated on the
characteristics plate with those of
the power supply in question. If
these data do not match there may
be problems. In case of doubt,
contact an electrician.
WARNING!
If the electrical wire plug is
removed, the appliance must be
installed and connected by a
technician. Contact a qualified
electrician who knows and respects
current safety standards. The
manufacturer cannot be held
responsible for damage resulting
from fitting or connecting errors.
WARNING!
The electrical safety of the
appliance can only be guaranteed
if it is earthed. The manufacturer
cannot be held responsible for
damage resulting from the absence
of or defects in the installation's
protection system (e.g. electrical
shock).
WARNING!
Only use the appliance once it has
been fitted into its built-in position.
Only in this manner can it be
guaranteed that users cannot
access the electrical components.
WARNING!
Never open up the appliance's
frame. Possible contacts with
electrical conducting parts or
that may be caused to people, animals
or property if these installation
instructions are not observed.
changes to electrical or mechanical
components may
represent a danger to users' safety
and prejudice the correct working
of the appliance.
WARNING!
Repairs and maintenance,
especially of parts carrying
electrical current, must only be
done by technicians authorised by
the manufacturer. The
manufacturer and retailers do not
accept responsibility for any
damaged caused to people,
animals or property as a result of
repairs and maintenance carried
out by non-authorised personnel.
WARNING!
Repairs undertaken during the
guarantee period must only be
done by technicians authorised by
the manufacturer. If this is not the
case then any damage resulting
from the repair in question is
excluded from the guarantee.
WARNING!
The appliance must be
disconnected from the electrical
current when installation and repair
work is being done. To disconnect
the appliance from the current, one
of the following conditions must
apply:
The switchboard fuses / circuit
breakers must be disconnected.
The plug should be removed from
the socket. To remove the plug from
the socket do not pull on the electric
cable but rather pull out the plug
itself directly.
ENGLISH 37