Installation Instructions; Before Installation; Electrical Connection - Electrolux WS 16 Mode D'emploi

36 ENGLISH

INSTALLATION INSTRUCTIONS

BEFORE INSTALLATION

Check that the input voltage indicated
on the characteristics plate is the same
as the voltage of the power outlet you
are going to use.
Open the drawer and take out all the
accessories and remove the packing
material.
Attention! The front surface of the
crockery heater may be wrapped in a
protective film. Before using the
crockery warmer for the first time,
remove this film carefully.
Make sure that the crockery warmer is
not damaged in any way. Check that
the drawer opens and closes correctly.
If you find any damage, contact the
Technical Assistance Service.
Attention: the power socket should be
easily accessible after the crockery
warmer has been installed.
The warming drawer should only be
built-in in combination with those
appliances indicated by the
manufacturer.
INSTALLATION
To build-in the appliance which is
combined with the crockery warmer,
follow the instructions set out in the
respective instructions and fitting
booklet.
Electrical installation must be
performed by an electrician qualified in
accordance with the legislation in
force.
Before connecting the crockery
warmer to the electric mains, check
that the voltage and frequency of the
mains matches that which is shown on
the rating plate located in the heating
block inside.
The electric connection is made via an
omnipolar switch, which is suitable for
the intensity to be tolerated and which
has a minimum gap of 3mm between
its contacts, which will ensure
The relevant installation dimensions
are indicated in mm in the diagrams
shown at the end of this booklet.
Proceed as follows:
1. Place the crockery warmer on the
shelf and slide it towards the
interior of the niche in such a way
that it is centred and completely
lined up with the front of the unit.
2. Check that the crockery warmer's
frame is properly levelled and is
sitting evenly on the shelf.
3. Open the drawer and fix the
crockery warmer to the sides of the
unit using the screws provided.

ELECTRICAL CONNECTION

disconnection in case of emergency or
when
cleaning the crockery warmer. If a plug
is used for the electric connection,
then it must be accessible after
installation.
The connection should include correct
earthing, in compliance with current
norms.
WARNING:
THE CROCKERY WARMER
MUST BE EARTHED.
If the flexible supply cable fitted to the
crockery warmer ever needs to be
changed, it should be replaced by an