LENCO DPF-155 Mode D'emploi page 6

All manuals and user guides at all-guides.com
Installing the Software / Hardware
IMPORTANT: You must install the software to your computer before
connecting the device to your computer for the first time.
1. Insert the CD-ROM and run the file SETUP_UT1.02.EXE;
Follow the onscreen instructions.
2. The application Photo Viewer will be installed on your computer
and a shortcut to the application will appear on your desktop.
DO NOT LAUNCH THE SOFTWARE YET.
3. After the software is installed, connect the device to the computer
with the USB cable supplied. The hardware drivers will be
installed automatically. Follow the on-screen instructions and
accept the installation screens that appear.
4. After hardware installation is complete, launch the PhotoViewer
application from the shortcut on your PC desktop.
NOTE: If you are unable to launch the software or connect to your
Photo Viewer, go to the Troubleshooting of this manual for
more information.
The internal battery of the device may be charged using the USB
cable when connected to a powered USB port(such as USB port on
your computer) or hub.It will be fully charged after two hours. At full
charge, the device can provide up to 3 hours of run time.
Charging the Battery
4