Seenergy CH300 Mode D'emploi page 7

 Ventilate the environment appropriately in case of a simultaneous
operation of the exhaust hood and any other equipment supplied by an
energy source other than electricity so that the exhaust hood will not draw
gas compounds.
 Attention! During the simultaneous operation of a suction-filtration
exhaust hood and a heating system independent of air (gas heaters, oil,
coal, chimney, etc...), great attention has to be placed so as to avoid that
the exhaust hood does not absorb part of the air intended for the
combustion process since dangerous amounts of carbon monoxide may
surge within the premises, that would represent a life-threatening danger.
When installing an exhaust hood joined or connected to a fuel element
such as a heater, chimney or local heating system, it is mandatory to
contact the producer or installer of such elements to obtain an optimal
and risk-free operation.
 It is necessary to maintain a depressurized environment of maximum 0.04
mbar. Such conditions allow an excellent working of the exhaust hood. In
order to achieve such environment a permanent air intake is necessary
in order to avoid air stagnation (it is advised to use a ventilation grid for
this purpose). Windows or doors shall not be used.
 The electrical supply of the power network shall be stable and cope with
the indicated electrical standards, 220/240v AC, 50Hz. Should it be not
stable and receive voltage variations in the supply, intensity or frequency
such as armonici, transistor, voltage dips, overloads, electrical storms,
etc..., the hood may show malfunctions or even breakdowns, and the
repair would not be covered by the warranty. In that case, the exhaust
hood shall be disconnected and the company must contact an electrician
or electrical company in order to solve the supply problem.
 The hood is a household appliance act to extract smoke , it can not be
used as support element of objects or utensils.
 In the constant effort to to improve our products, we reserve the right to
make changes following their enhancement to their technical, functional
and aesthetic characteristics.
WARNINGS
EN/3