Seenergy CH300 Mode D'emploi page 32

Procedure for fixing

Dimensional Drawings

Follow the directions of the template for drilling
Connecting and fitting
Before connecting the appliance, check the household installation.
Appliance without power cable:
necessary, fit the copper bridge supplied. Mains power cable: Type H05 VV-F or a higher
grade, min. wire cross-section 1.5 mm2.
Appliance with prefitted power cable:
trained after-sales engineer.
Installing: Do not trap the power cable and do not route it over sharp edges. If the oven
is a built-under type, route the cable on the rear corners of the oven to the socket.
Electrical Connection
Connect the device to the mains and check the operation:

voltage, see the rating plate

connect adhering strictly to the relevant diagram
1. Brown
2. Blue
3. Yellow and Green
Wiring Diagram
INSTALLATION
Only connect as shown the connection diagram. If
The power cable must only be replaced by a
EN/1