Samsung MM-J320 Mode D'emploi page 14

TV SoundConnect
You can listen to the sound from your
SoundConnect Compatible Samsung TV
through the Micro Component by using the TV
SoundConnect function.
Connecting the Micro Component to a
SoundConnect Compatible Samsung TV
Before activating this function, be sure to activate
the Samsung TV's SoundConnect or SoundShare
mode.
1. Press the FUNCTION button on the main unit
or the button on the remote control to
display the TV SOUNDCONNECT message.
WAIT ; SEARCH ; REQUEST
2. Set Add New Device to On in the TV's
SoundConnect Settings menu. (Refer to the
TV's user manual for details.)
3. When the Micro Component is connected to
the TV, it will display [TV] Name ; TV on the
front display.
4. The audio from the connected TV plays over the
Micro Component System.
• In TV SoundConnect mode, the Play/
Repeat/Stop/Next/Back functions are not
available.
• The SoundConnect feature is available on
some Samsung TVs released since 2012.
Check whether your TV supports the
SoundShare or SoundConnect function.
(For further details, refer to the TV's user's
manual.)
• If you unplug the Micro Component, the TV
SoundConnect connection is terminated. To
re-establish the connection, plug the Micro
Component into an outlet, and then set the
TV SoundConnect connection again.
• Only one Micro Component at a time can be
connected to a TV via TV SoundConnect.
• To connect to another TV in TV
Soundconnect mode, press the p button
for more than 5 seconds, and then connect
to the other TV by following the directions
above.
To disconnect the TV from the Micro
Component
You can disconnect the TV from the Micro
Component.
For instructions, see the TV's user manual.
14
English
All manuals and user guides at all-guides.com
• When the Micro Component is disconnected
from the TV, the Micro Component will display TV
DISCONNECTED ; REQUEST on its display.
To disconnect the Micro Component from the
TV
Press another mode button on the front panel
of the Micro Component to switch from TV
SoundConnect mode to another mode or turn off
the Micro Component. The currently connected
device is disconnected.
• The connected TV will wait a certain amount of
time for a response from the Micro Component
before terminating the connection.(Disconnection
time may differ, depending on the TV)
• The connection may be lost or sound may stutter
if the distance between the TV and the Micro
Component exceeds 6.5 feet (2 m).
• Instability in the network environment may cause
the connection to be lost or sound to stutter.
• In TV SoundConnect mode, the Micro
Component automatically turns off after 25
minutes if it is not connected to a TV.
Setting the Clock
During each step, you have a few seconds to set
the required options. If you exceed this time, you
must start again.
1. Switch the system on by pressing the POWER
2. Press the TIMER CLOCK button and then
3. Press the ENTER (
4. When the correct hour is displayed, press the
5. When the correct minute is displayed, press the
( ) button.
press the ENTER ( ) button, "CLOCK" is
displayed.
) button. The hour
flashes.
• To increase the hours, press: ,
• To decrease the hours, press: .
ENTER ( ) button. The minutes flash.
• To increase the minutes, press: ,
• To decrease the minutes, press: .
) button. " TIME" appears in the
ENTER (
display.
• The current time is now set.
• You can display the time, even when you are
using another function, by pressing the
TIMER CLOCK button once.