Beper VE.118 Manuel D'instructions page 10

Stand Fan Use instructions
PRODUCT AND ACCESSORIES Fig.A
1. Front grid
2. Grid locking hooks
3. Nut blades
4. Blades
5. Rear grid nut
6. Rear grid
7. Motor
8. Swing button
9. Control panels
10. Telescopic tube
11. High adjustment nut
12. Base
13. Screw-cover plate
FAN ASSEMBLY Fig.B
1. Place the base on the floor.
2. Insert the telescopic tube on the base and assure with the 4 screws.
3. Loosen and remove the high adjustment nut.
4. Insert the screw-cover plate on telescopic tube than relocate the high adjustment nut.
5. Insert the motor on the telescopic tube and fix it with the appropriate screw.
6. Insert the back grid, making sure to match the holes with the pins.
7. Fix the back grid with the appropriate nut.
8. Insert the blades.
9. Fix the blades with the appropriate ring, turning counterclockwise.
10. Fix the front disc to the front grid.
11. Insert the front grid and fix it with the appropriate locking hooks and screw.
Important: Firmly weld all components to ensure good stability of the fan, otherwise it could oscillate
dangerously.
SPEED SELECTION
Choose the speed desired pressing on the buttons of the control panels.
Position 0 the fan switch off.
Position 1 low speed.
Position 2 medium speed.
Position 3 high speed.
HEAD INCLINATION
It is possible to choose various positions and change the air flow swing.
Before changing it, switch off the fan.
Take the motor body and change the inclination of the fan as desired, by snap.
Attention : Do not try to force the inclination in order to avoid any failure.
SWING
It is possible to activate or disconnect the swing of the fan, by touching appropriate button. Swing allow to provide
the air uniformly.
To activate the swing push the button down until completely blocked ; the head fan turns automatically from right
to left.
To disconnect the swing raise the button completely.
CLEANING
Before cleaning, switch off and unplug the fan.
For cleaning use a soft cloth, that may be softly wet.
Do not use alcohol or chemical substances, or any detergent that could damage this appliance.
Do not allow water or other liquids to penetrate in the fan, in order to protect it.
After cleaning, dry every parts before using the appliance.
During the winter and when not used, keep this appliance in a dry and clean place.
10