Bessey EBH Serie Mode D'emploi page 14

5.1 Heating a hanging workpiece
• Place the induction crossbar with the bearing on the poles. Make sure that the bare metal
side is positioned straight on the poles.
• Always choose an induction crossbar that fills the bore of the bearing as much as possible.
You can even use 2 crossbars at the same time. This promotes optimal, fast and even heating.
• Make sure that the bare-metal sides are sufficiently coated with acid-free grease to ensure
optimal contact and avoid vibration.
• Always make sure that the workpiece does not come into contact with the plastic casing
of the heater. When the heating is finished, follow the instructions in reverse order. Use
heat-resisant gloves to move the heated workpiece.
5.2 Heating a horizontal workpiece
• This is only possible if the bore of the workpiece is large enough to fit over the pole.
• Place the workpiece as centrally as possible around the pole on the horizontal supports.
• The workpiece may not be wider than the horizontal supports.
• Always choose the largest induction crossbar.
• Make sure that the bare-metal sides are sufficiently coated with acid-free grease to ensure
optimal contact and avoid vibration.
• Always make sure that the workpiece does not come into contact with the plastic casing of
the heater.
• When the heating is finished, follow the instructions in reverse order. Use heat-resistant
gloves to move the heated workpiece.
14 © Bessey Tools