Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
COMPONENTS (SEE PAGE 2)
Protective grille
1
Hot air outlet
2
Control Panel
3
Metal base
4
CONTROL PANEL (SEE PAGE 3)
Power increase button
A
[ HOT HEAT ] (1,500 W) operation indicator
B
[ WARM HEAT ] (1,000 W) operation indicator
C
[ FAN ] operation indicator (0 W)
D
Power decrease button
E
USE PRECAUTIONS
• This unit is only suitable for well insulated rooms or occasional use.
• Make sure that the product is placed on a dry and plane surface.
• Leave at least 50 cm of space at the back, sides and front of the unit.
• Parts of this product may become very hot and cause burns. Pay particular attention when
using near children and/or vulnerable persons.
12
Cold air inlet grille
5
Main switch of the appliance
6
Power supply cord
7
OPERATING INSTRUCTIONS
1. Plug the unit.
2. Press the main switch on the back of the unit () to turn it on. The unit is now in standby mode.
3. Press the [ + ] () button to turn on the unit. The heater will turn on in [ FAN ] mode. The Fan
operation indicator () will light up.
4. Press the [ + ] button again to increase the power and enter [ WARM HEAT ] mode. The Warm
Heat operation indicator () will light up.
5. If you press the [ + ] button a third time, the power will increase again and enter [ HOT HEAT ]
mode. The Hot Heat operation indicator () will light up.
6. When the room temperature is pleasant enough, press the [ - ] () button to reduce power
consumption and prevent the room from overheating.
7. To turn off the unit, press the [ - ] button until all indicator lights are off. The heater will continue
to operate and blow air for a few seconds after being turned off.
8. If you are not going to use your auxiliary heater for a long period of time, turn the main switch
() on the back of the unit to the OFF position.
MAIN FUNCTIONS
[ + ] AND [ - ] BUTTONS
Easily adjust the power of your additional heater using these two buttons. You can switch
between [ FAN ] Mode, [ WARM HEAT ] Mode and [ HOT HEAT ] Mode.
ADDITIONNAL FUNCTIONS
INCLINAISON
Rotate the body of the appliance up to 50°, to point it in the direction you want it to be.
However, be careful to do this when the additional heater is cold.
13
Publicité
Table des Matières
