ACERBIS CARLINO KID Mode D'emploi page 17

• Always wear your helmet well fastened when riding, to make the most of its
protective capacity.
• Do not expose the helmet to gasoline fumes or other solvents directly, as it may
damage the shell, the protective layer and other helmet components and
mechanisms.
• Do not travel with the helmet hanging from the bike as this could damage not
only the paint and the face shield, but the chin strap as well.
• Always keep it away from the mu er, exhaust fumes and heat sources such as
the tail boxes. In summer, when stopping for a break, protect it from direct
sunlight, especially if the helmet is dark.
• Never use a dark or tinted face shield at night or in poor visibility conditions.
• Do not, under any circumstances, tamper with your Acerbis helmet. Do not cut
or puncture the helmet shell, do not insert screws and do not paint it. Do not
modify the chinstrap. Do not remove the lower part of the helmet or the face
shield, it can be very dangerous in case of an accident. Do not alter the inside
of the helmet. Above all, do not cut or remove part of the polystyrene as this
would significantly reduce the chances of absorbing shocks. Use original
Acerbis spare parts.
• Prevent the helmet and its lining from being "chewed" or "scratched" by a pet,
the damage caused could prove irreparable.
• Do not hang your helmet on the rear-view mirror or handlebar to avoid
damaging the inner lining.
• Avoid exposing your helmet to intense light sources. If your helmet comes in
one of the following fluorescent colours: yellow, orange, red, green, remember
that these colours are not light-resistant.
EN
16