Makita DFS452RTJ Manuel D'instructions page 60

Reversing switch action
A
► 1 . Reversing switch lever
Always check the direction of
CAUTION:
rotation before operation.
Use the reversing switch only after
CAUTION:
the tool comes to a complete stop. Changing the direc-
tion of rotation before the tool stops may damage the tool.
When not operating the tool,
CAUTION:
always set the reversing switch lever to the neu-
tral position.
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
A side for clockwise rotation or from the B side for coun-
terclockwise rotation.
When the reversing switch lever is in the neutral posi-
tion, the switch trigger cannot be pulled.
Selecting the action mode
Do not rotate the action mode changing
NOTICE:
knob when the tool is running. The tool will be damaged.
To avoid rapid wear on the mode
NOTICE:
change mechanism, be sure that the action mode
changing knob is always positively located in one
of the action mode positions.
Rotation with hammering
For drilling in concrete, masonry, etc., rotate the action
mode changing knob to the
bide-tipped drill bit.
1
► 1 . Action mode changing knob
1
symbol. Use a car-
Rotation only
For drilling in wood, metal or plastic materials, rotate
the action mode changing knob to the
twist drill bit or wood drill bit.
B
1
► 1 . Action mode changing knob
ASSEMBLY
CAUTION:
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Side grip (auxiliary handle)
CAUTION:
safe operation.
CAUTION:
side grip, make sure that the side grip is irmly
secured.
Install the side grip so that the grooves on the grip it in
the protrusions on the tool barrel. Turn the grip clock-
wise to secure it. The grip can be ixed at desired angle.
► 1 . Side grip
Grease
Coat the shank end of the drill bit beforehand with a
small amount of grease (about 0.5 - 1 g).
This chuck lubrication assures smooth action and lon-
ger service life.
7 ENGLISH
Always be sure that the tool is
Always use the side grip to ensure
After installing or adjusting the
1
symbol. Use a