Gewiss Chorus GW 10 766 Mode D'emploi page 29

IN SERVICE
All manuals and user guides at all-guides.com
Using the local command button
The local command button (figure A) is used to perform the ON/OFF cyclical switching,
inverting the relay status each time they are pressed.
If the actuator can be commanded in timer mode by at least one KNX/EIB device then also
the local command button will send a timed command.
Local commands are not executed if a priority control is active.
Behaviour on the failure and
reinstatement of the bus power supply
If the power to the bus decreases below 18 V dc for over 1.5 ms the relay switches
to OFF (NA contact open, NC contact closed).
When the power is reinstated on the bus, the relay remains in OFF mode.
Maintenance
This device requires no maintenance. Use a dry cloth for possible cleaning.
24