Other Functions - Alecto WS-1650 Mode D'emploi

Masquer les pouces Voir aussi pour WS-1650:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OTHER FUNCTIONS

To manually set the clock:
Only follow these instructions when the WS-
1650 doesn't receive the DCF77 signal.
1. Press and hold the CLOCK (16) button
for at least 3 seconds until the year
display starts flashing.
2. Use the UP and DOWN (11 and 12) but-
tons to adjust the following settings one
after the other and confirm each setting
by briefly pressing the CLOCK (16) but-
ton:
− year
− month
− day
− hours
− minutes
3. After pressing the CLOCK button for the
last time, the time and date are set.
To manually activate the DCF-77 receiver:
With the WS-1650 in standby mode, press
and hold the DOWN (12) button for 3 sec-
onds to activate the radio receiver again for
the reception of the atomic time. However,
the receiver of the WS-1650 automatically
checks whether the signal is being received.
The daily synchronization with the DCF-77
station occurs at 2am, 3am, 8am, 12pm,
2pm and 8pm.
Around 2am and 3am the reception sensitiv-
ity is the highest.
EXPANSION
You may connect up to 3 outdoor units to
the indoor unit. You can then read the tem-
perature and humidity at 3 different locations
on the indoor unit (e.g. in your greenhouse,
in animal accommodations, in different
bedrooms).
Additional outdoor units are available via the
service department of Alecto: www.alecto.nl.
To register additional outdoor units:
1. Insert 2 batteries into the new outdoor
unit according to section INSTALLA-
TION – Outdoor unit power supply.
2. Slide the channel switch at the rear of
the outdoor unit (9) to the desired posi-
tion CH 1, 2 or 3, provided the position
is not yet in use.
3. Now press and hold the CHANNEL (15)
button (indoor unit) for at least 3 sec-
onds until the display icon
flashing.
4. For each outdoor unit, now press the TX
(7) button behind the battery cover. The
measured value with the channel num-
ber appears in the display of the indoor
unit.
5. Now press and hold the CHANNEL (15)
button to confirm the input. The outdoor
unit is now registered.
ATTENTION: Don't use the same channel
twice; the outdoor units will interfere with
each other.
21
(29) starts

Publicité

Table des Matières
loading

Table des Matières