Technoline WT195 Manuel D'instructions page 14

WT195 – RADIO CONTROLLED CLOCK WITH TEMPERATURE
USER' INSTRUCTIONS
Please read the instructions carefully and keep the manual well for future
reference.
GETTING STARTED

Remove the battery door.

Install two new AA size batteries as per the polarity information marked
on the battery compartment.

Replace the battery door.

Once the battery is installed, the normal segments of the LCD will be
shown before entering the radio controlled time reception mode.

The RC clock will automatically start scanning for the radio controlled
time signal in 8 seconds.
Note
If no display appears on the LCD after inserting the battery, press the
"RESET" key by using a metal wire. In some cases, you may not receive
the signal immediately. Due to the atmospheric disturbance, the best
reception often occurs during nighttime.
GB 1