Grape WSR-1000 Mode D'emploi page 3

Connection Illustration
Connection
Step 1: Connect the WSR-1000 Transmitter to a source device (HD Set-top-box, Blu-ray player, PC
etc.) with a HDMI cable. Connect the HDMI cable to HDMI IN on the Transmitter from the
HDMI OUT on the source device.
If you want to connect the source device wired to a nearby display device (loop through) you
can do so by connecting a HDMI cable from the HDMI OUT on the Transmitter and to an HDMI
IN on the display device.
Step 2: Connect the Receiver to the display device (TV, Projector, etc) with a HDMI cable. Connect the
HDMI cable from HDMI OUT on the Receiver to a HDMI IN on the display unit.
Step 3: Connect the IR emitter to the IR OUT on Transmitter. Place the IR emitter in front of the IR
receiver on the source device.
(If you do not need the IR extending function, please skip step 3 and 4)
Step 4: Connect the IR receiver to the IR IN on WSR-1000 Reciever. Place the IR receiver so you
can point the remote control of the source device at it.
(If you do not need the IR extending function, please skip step 3 and step 4)
Step 5: Connect a DC 5V/1A power adaptor to each of the Transmitter and Receiver. Connect the
power jack (MicroUSB) to the
Step 6: The WSR-1000 is now connected. If you do not have an image on your display, please pair the
Transmitter and Receiver. First, press the MODE key on Transmitter and then on
Receiver – see more in section "B" on next page.
All manuals and user guides at all-guides.com
Setup your WSR-1000
.
3