Publicité
Les langues disponibles
Les langues disponibles
leG Assembly
1. Lay right side panel (#2) face down on a soft surface
to avoid marking finish. Attach three brackets with 1/2"
screws to bottom of right front leg (#3), leaving screws
slightly loose. Face brackets out toward tongued side
(see Figure 1). Place right front leg over right side (#2)
matching groove in leg to tongue on side, as shown in
Figure 1, matching trim pieces on side with trim on front.
Align threaded holes with brackets on side. Start three
1/2" screws through brackets. Align bottom of side and
leg assembly so they are flush with each other. Hold
these pieces securely in alignment while tightening (but
not over tightening) screws.
2. Assemble left side (#4) and left leg (#5) as described in
step 1.
1/2" Screw
Leg Side (#4)
Bracket
Groove in
Leg Front
Leg Front (#3)
Tongue on
Leg Side
Figure 1 - right and Left Leg assemblies
Right
Side/Leg
Assembly
Bracket
1/2" Screw
Figure 2 - Leg assembly to Base
2
3. Attach 6 brackets to base (#1) at threaded hole locations
4. Place right side/leg assembly on base and align threaded
5. Assemble left side/leg assembly to base following step #4.
HeADeR Assembly
1. Using 1/2" screws, secure brackets to 2 threaded holes at
2. Place header (#6) into position on top of leg assemblies
Tongue on
Leg Side
3. Be sure alignment is correct and spaces are at a mini-
Leg Front (#5)
Groove in
Leg Front
Bracket
1/2" Screw
Leg Side (#2)
Base (#1)
www.desatech.com
using 1/2" screws leaving screws loose. Face brackets
toward outside.
holes with brackets. Start 1/2" screws through brackets
into threaded holes in side/leg assembly. Back of side/
leg assembly should be flush with back of base. Assure
alignment is correct and spaces are at a minimum. Leave
screws slightly loose.
both ends of header (#6). Turn brackets to the outside.
with arrow pointing up. Bottom of header will slide behind
upper portion of leg front panels and rest on shoulders
(see Figure 3). Align bracket holes with threaded inserts in
leg assemblies. Using four 1/2" screws through brackets,
attach header to leg assemblies. Leave screws loose.
mum having at least one person holding panels securely.
Tighten all screws with Allen wrench provided.
Shoulder of
Leg Front
Panel
Figure 3 - attaching Header
Header (#6)
Threaded
Insert
121341-01A
Publicité
