AVS Bugflector Instructions D'installation page 2

Installation Steps
1
Expose 2" (5 cm) of tape liner from each end
of the flanges on the hood shield.
3
Remove remainder of tape liners. Apply strong
pressure at all contact points for proper adhesion.
5
Close hood.
7
All manuals and user guides at all-guides.com
NOTE: Actual application may vary slightly from illustrations.
Open Hood.
Clean leading edge of hood with
2
Center part on front edge of hood. If necessary
slide flanges under rubber trim.
4
Secure with (4) self tapping screws through
hood shield into sheet metal. NOTE: Toyota
Camry and Pontiac Sunfire have only (2)
6
NOTE: DO NOT OVER TIGHTEN
Apply bump ons to surface of hood.
8
14
7
Page 2 of 3
alcohol pad.
screw mounting locations.
Bump-on
hood
washer
screw
hood shield