Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION INSTRUCTIONS - SLD2
AA-38
(REFERENCE)
ARM ASSEMBLY
SLD/PM/4S
(REFERENCE ONLY)
FIXTURE ASSEMBLY
4" OD POLE
(REFERENCE)
NOTES:
For replacement LED Assemblies and Drivers please contact Current Lighting for any replacement parts.
Contact your local distributor or agent to confirm parts availability prior to ordering replacement parts.
95059205 Rev. A
701 Millennium Boulevard Greenville, SC 29607 (864) 678-1000
SAVE THESE INSTRUCTIONS
Arm Mount
INSTALLATION STEPS:
1. Turn off all power to the unit and take proper safety precautions.
2. Remove clevis pin and cotter and set aside. Loosen (3) set
screws in arm coupling
3. Connect fixture leads to feed wires (Verify supply voltage against
fixture labeling), secure with wire tie or other means of stress relief
to prevent disconnection. Push wires into the arm.
4. Insert luminaire into arm, line up pin through-holes. Pass pin
through aligned holes. Attach cotter to the end of pin.
5. Apply Loctite 262 to the threads of the set screws. Tighten set
screws evenly in an alternating pattern.
NOTE: The pin will temporarily support the luminaire but the
installation should not be left unattended until the luminaire is
properly secured with screws.
6. Turn on power and test fixture.
7. Installation is complete.
Tools Required:
•
Hex (Allen) Wrench - 5/32
(1) PIN AND COTTER
(3) SET SCREWS
TORQUE SCREWS TO
144 IN LBS
WIRE CONNECTORS
(BY OTHERS)
NOTE STREET SIDE LABEL AND ORIENT FIXTURE ACCORDINGLY
TO INCOMING
POWER SOURCE
STREET
SIDE
SHEET 2 OF 8
J-BOX
FIXTURE
BLACK
LINE
COMMON
WHITE
GROUND
GREEN
DIM (+)
VIOLET(+)
DIM (-)
PINK(-)
NOTE:
VIOLET & PINK WIRES FOR
DIMMING OPTIONAL.
(WIRE COLOR MAY VARY
BASED ON SUPPLY
VOLTAGE )
www.currentlighting.com
Publicité
