Publicité
AUTOMATIC MODE
n
Set the selection knob to
ing on the timer you are setting. The display shows “
number and “1” is the cycle number. The number “1” is flashing.
n
Using the adjustment knob, select the cycle (or channel) number.
n
Press the push-button once. The current On/Off status of the selected cycle is
displayed and flashes.
n
Use the adjustment knob to enable or disable the selected cycle. Turn the knob to
the right to enable, or to the left to disable.
n
Press the push-button once again. The current start time is displayed with the
hours flashing, alternating with the letters
n
Use the adjustment knob to set the hours.
n
Press the push-button. Now the minutes of the start time begin flashing, alternat-
ing with the letters
n
Use the adjustment knob to set the minutes.
n
Press the push-button. The currently defined running time is displayed with the
minutes flashing, alternating with the letters
n
Use the adjustment knob to set the minutes. The maximum value is 99 minutes.
n
Press the push-button. Now the seconds of the running time begin flashing,
alternating with the letters
n
Use the adjustment knob to set the seconds.
n
Press the push-button to store the new parameters and select another cycle.
8
TC4-T3O.rev.05
,
(start).
.
or
” where n is the timer
(start)
(running).
depend-
Publicité
