Publicité
Example of Overlapping Cycles on the Same Timer:
Cycle 1 — Start Time: 8:30; Running Time: 90 min
Cycle 2 — Start Time: 9:30; Running Time: 60 min
Actual Execution:
Cycle 1 starts at 8:30
MODE OPERATION
Each timer operates independently from the others in one of four modes: AUTO-
MATIC mode, SKIP-A-DAY mode, ON mode and OFF mode. In automatic mode, the
timer activates the output automatically according to the cycle settings. In skip-a-day
mode, the timer operates every other day (see below). In On mode, the timer output
is forced into an active state. In Off mode, the timer output is forced into an inactive
state: all programming is stopped even if cycles for that timer are currently enabled.
n
Set the selection knob to
mode setting for the timer .
n
Using the adjustment knob, select the mode: —
for skip-a-day mode —
n
Wait 2.5 seconds until the display stops flashing. If you turn the selection knob to
another position before the display stops flashing, the change will not be saved.
n
If you have selected automatic mode, you can press the push-button once to
display the cycles that are currently enabled for the selected timer. If you have
selected skip-a-day mode, you can press the push-button to choose when to start
skipping. When the Skipping LED is on, the current day is being skipped for all
three timers. When the Skipping LED is off, the next day will be skipped for all
three timers.
Cycle 1 ends at 10:00
Cycle 2 starts at 10:00
depending on the timer you are setting. The display shows the current
for manual on mode —
Cycle 2 ends at 11:00
,
for automatic mode —
for manual off mode
or
7
TC4-T30.rev.05
Publicité
