Pioneer KURO KRP-TS02 Mode D'emploi page 13

Attaching the Pioneer Display and Television
The weight of a Pioneer display and television is
about 30 kg (66 lbs), they have no depth, and are
unstable. Therefore, at least two people must
�������
assemble and install them.
����
• Be sure to install it on a flat stable location.
• Insert the screws in the holes vertically and securely tighten.
• Place a sheet or other material under the display to prevent
scratches or damage to it.
• After manually turning the screw lightly two or three times,
tighten it with a screw-driver.
1
Attaching the Pioneer display and
television to the stand.
Lay the Pioneer display and television down flat. Align the
stand supports with the Pioneer display and television
stand slots, and slowly insert the supports horizontally.
Please ensure that the stand supports do not come into
contact with anything other than the Pioneer display and
television stand slots. Contact with any other area may
result in scratching or deformation of the display's rear
side or terminals.
����
�����
����
When laying down the Pioneer display and television, be
careful so as to not scratch or damage it.
2
[PDP-LX5090 / PDP-LX5090H / PDP-LX509A / PDP-C509A]
KRP-TS02 / PDK-TS33A / PDK-TS33
Upper .................... Installation screw
Bottom ...................Installation screw
[KRP-500P / KRP-500M]
KRP-TS02
Upper .................... Installation screw
Bottom ...................Installation screw
��������������������
�������������������
Get other manuals https://www.bkmanuals.com
Securing the Pioneer display and television
with Installation screws.
Secure the parts marked with the arrows (holes marked
"T") using a Phillips screwdriver.
�
�
����
�����
(M8 × 40 mm: black)
➁
(M8 × 15 mm: black)
➃
(M8 × 23 mm: black)
➂
(M8 × 15 mm: black)
➃
�������������������
��������������������
�
���������������������
��������������������
�
13
En