Taurus MIXING CHEF COMPACT Mode D'emploi page 10

- Keep the appliance in good condition. Check that the moving parts are not
misaligned or locked and make sure there are no broken parts or anomalies
that may prevent the appliance from operating correctly.
- Never leave the appliance unattended while in use.
- Never leave the appliance connected and unattended if is not in use. This
saves energy and prolongs the life of the appliance.
- Do not use the appliance for more than 10 minutes at once. Let it cool for
down for a couple of minutes before using again.
Service:
- Make sure that the appliance is serviced only by specialist personnel, and
that only original spare parts or accessories are used to replace existing parts/
accessories.
- Any misuse or failure to follow the instructions for use renders the guarantee
and the manufacturer's liability null and void.
Instructions for use
Before use:
- Make sure that all the product's packaging has been removed.
- Before using the product for the first time, clean the parts that will come into
contact with food in the manner described in the cleaning section.
- Prepare the appliance according to the function you wish to use.
Use:
- Take the length of cable required out of the housing.
- Connect the appliance to the mains.
-The LED display will light up, displaying 00:00
- Press gently with your hand on the upper part while pressing the connect/
disconnect button to raise the upper part (Fig. 1)
- Place the bowl on base and position as shown (Fig. 2)
- Place the accessory that will be used on the mounting, ensuring that it fits over
the hole and turn in an anti-clockwise direction until it is tightly fitted (Fig. 3)
- Press the connect/disconnect button and press the upper part downwards until
the button is returned to its original position (Fig. 4)
- Put the lid on to prevent splashing.
- Start the appliance by turning on the speed regulator.
- If no specific operating time has been programmed, the LED display will show
the time that has elapsed since the operating speed was selected.
- To avoid a fierce start up of the fan, it is advisable to start off from the lowest
speed position and, once the fan has been switched on, progressively increase
the speed to the desired position.
Electronic speed control:
- The speed of the appliance can be regulated by using the speed regulator
control (D). This function is very useful, as it makes it possible to adapt the
power of the appliance to the type of work that needs to be done.
- The speed control can be used for the desired function as is described in the
accessories section.
Timer function:
- The appliance's operating time can be controlled.
- To set an operating time simply select it by using the time selection buttons
(G) to a maximum of 10 minutes, with 10 second intervals. By keeping "+" or "-"
pressed, the selected time will change more quickly.
- The programmed time or remaining time will be shown on the LED display (F).
- By selecting the desired speed the LED display will show the remaining time
in 1 second intervals.
- The time and operating of the appliance can be paused by moving the selector
knob to "0". Time and operating will resume once the speed has been selected
again.
- Once the programmed time has elapsed, the appliance will stop. Move the
selector knob to "0".
- To change the set time move the selector knob to "0" and press "+" or "-" to
reset the desired time. Once selected, reset the desired operating speed.
- To reset the timer, select "0" and then press both select time buttons at the
same time until 00:00 is shown on the LED display.
- If a specific operating time has not been set, the LED display will show the
time elapsed since the operating speed was selected.
Once you have finished using the appliance:
Turn off the appliance by selecting 0 on the speed regulator.
- Unplug the appliance to the mains.
- Put the cable back in the cable housing.
- The cable housing enables the cable to be stored and pulled out to the requi-
red length for operating the appliance, preventing hazardous situations.
- Take off the lid.
- Press the connect/disconnect button of the upper part, while raising the upper
part.
- Remove the bowl from the base by turning it in an anti-clockwise direction.
- Clean the appliance
Manual Mixing Chef Compact.indb 10
All manuals and user guides at all-guides.com
Accessories:
Whisk accessory (H):
- This accessory is used for whipping cream, stiffening egg whites, making
smoothies, light cakes, meringues, mousses and soufflés.
- Do not use this accessory for mixing heavy masses (e.g. fat and sugar) as it
may damage the appliance.
- Use the speed control to gradually increase until reaching the maximum
setting.
- Note: minimum quantity of 3 eggs, maximum quantity of 12.
Mixer accessory (K):
- This accessory is used for mixing food, making biscuits, pasta, fillings and
mashed potatoes.
It is recommended that intermediate speeds are used from 2-6, depending on
the type of mixes.
Kneading accessory (H):
- This accessory is used for kneading bread, pizza dough and dense cakes.
- Do not use speeds greater than 1.
- Maximum quantity of flour: 1,200 gr.
Safety thermal protector:
- The appliance has a safety device, which protects the appliance from
overheating.
- If the appliance turns itself off and does not switch itself on again, disconnect it
from the mains supply, and wait for approximately 15 minutes before reconnec-
ting. If the machine does not start again seek authorised technical assistance.
Cleaning
- Disconnect the appliance from the mains and let it cool before undertaking
any cleaning task.
- Clean the equipment with a damp cloth with a few drops of washing-up liquid
and then dry.
- Do not use solvents, or products with an acid or base pH such as bleach, or
abrasive products, for cleaning the appliance.
- Do not let water or any other liquid get into the air vents to avoid damage to
the inner parts of the appliance.
- Do not submerge the appliance in water or any other liquid, or place it under
a running tap.
- It is advisable to clean the appliance regularly and remove any food remains.
The appliance is suitable for cleaning in hot soapy water or in a dishwasher
(using a soft cleaning program):
- After washing, dry all the parts before fitting them together and storing.
Anomalies and repair
- Take the appliance to an authorised technical support service if problems
arise. Do not try to dismantle or repair without assistance, as this may be
dangerous.
For EU product versions and/or in the case that it is requested in your country:
Ecology and recyclability of the product
- The materials of which the packaging of this appliance consists are included in
a collection, classification and recycling system. Should you wish to dispose of
them, use the appropriate public recycling bins for each type of material.
The product does not contain concentrations of substances that could be
considered harmful to the environment.
This appliance complies with Directive 2006/95/EC on Low Voltage, Directive
2004/108/EC on Electromagnetic Compatibility, Directive 2011/65/EC on the
restrictions of the use of certain hazardous substances in electrical and electro-
nic equipment and Directive 2009/125/EC on the ecodesign requirements for
energy-related products.
- Bowl
- Lid
- Spatula
This symbol means that in case you wish to dispose of the product
once its working life has ended, take it to an authorised waste agent
for the selective collection of waste electrical and electronic
equipment (WEEE)
24/03/14 12:20