Keyton SensorScan Manuel D'utilisation page 9

operating the chair
Activating a new remote control
Before using a new remote control or a different one:
a) Unplug the chair for 2 minutes.
b) Plug the chair and press ON/OFF on the main control panel of the chair.
c) Once the led of the key ON/OFF of the main control panel is on, press the key ON/OFF of the
remote control. On the screen you will see a drawing of a person as long as there is a connection
between the remote control and the chair.
In case there are two or more chairs with remote control, you must never perform simultaneously the process of
ACTIVATING A NEW REMOTE CONTROL. You must finish the process with one chair and then start with the
next one.
On and off functions of the remote control
Press the key ON/OFF of the remote control to turn it on or off.
If the main control panel is not turned off, the remote control will switch off 16 minutes after the last time you
pressed a key.
If case the remote control does not work
a) Check the state of the batteries. ATTENTION: USE ONLY ALKALINE BATTERIES (SIZE "AAA"/LR03).
b) The remote control has been designed to work within to the armrest area. You should not use it out this
area.
ON/OFF
Press this key to turn on and off the remote control and the chair.
Stops the massage and the recliners
Press this key to stop all massage functions and to bring the mechanisms to the resting position.
Low batteries
If this led blinks, change the batteries in the rear part of the remote control.
All manuals and user guides at all-guides.com
9