Locating - Loc8tor Pet Mode D'emploi

LOCATING – SEARCHING FOR A PET
LOST
• Press and hold down the ON button until the Loc8tor beeps and lights flash.
• Press the button that your Pet / Tag is allocated to.
• Loc8tor will beep and status light will flash rapidly as it's searching for the Tag.
• When a Tag is detected the locating lights will light up and the audio will start.
• With the Loc8tor in your hand turn around slowly completing a full circle.
• As you point in the right direction and then move nearer to the item, the audio
pitch and frequency of beeps will increase, and lights on the Loc8tor change
from red to amber to green.
• Once a circle has been completed, face in the direction of the strongest audio
and visual signal and walk in that direction.
• When you see three green lights the Tag is very close by.
• To guide you right in, the Loc8tor now changes to 'zooming in' mode (pictured).
As you get closer amber then red lights illuminate and the audio pitch increases.
FOUND
To stop a search press the ON/OFF button, or the locate button your Tag is allocated to.
LOCATING TIPS
• Place the Tag on a surface and practice locating it a few times
to get a feel for how it works.
• If you are ever unsure of which direction to go in, slowly repeat
a full 360° circle and then go in the direction with the strongest
signal strength.
• Strongest signal is displayed when the Loc8tor is pointing
directly at the Tag. Try moving the Loc8tor up and down as the
Tag could be upstairs or downstairs.
• If you are close to a wall whilst getting a strong signal check
the room next door.
• Try pressing the volume button on the Loc8tor when you are
close in order to mute and listen out for Tag beeps.
• If no signal is displayed try moving position to a different area
and repeat the process.
6
www.loc8tor.co.uk www.loc8tor.com