Routine Care Of Cleaner; Cleaning Secondary Foam Filter; Replacing Hepa Exhaust Filter - Panasonic QuickDraw MC-V7319 Manuel D'utilisation

ROUTINE CARE OF CLEANER

Performing the following tasks will keep your new Panasonic vacuum cleaner operating at
peak performance levels and will ensure these high levels for years to come. Check the
BEFORE REQUESTING SERVICE section in this manual for recommendations on performing
some of these tasks to help solve various problems that may occur.

Cleaning Secondary Foam Filter

Secondary HEPA Filter
(White Side Up)
Filtre secondaire de type HEPA
(Côté blanc sur le dessus)
Filtro de HEPA secundario
(Blanca hacia arriba)

Replacing HEPA Exhaust Filter

HEPA
Exhaust Filter
and Frame
Filtro de escape
HEPA y el marco
Filtre d'évacuation
(HEPA) et cadre
Retainers
Lengüetas
Taquets
➢ The secondary foam filter protects
the motor.
➢ Check filter when installing a new
dust bag.
Rib Projections
➢ If dirty, pull filter from bottom of dust
Rainures
Lengüetas
compartment and clean by rinsing in
water.
➢ When dry, slide filter back into place.
➢ Ensure filter is fully inserted under
plastic rib projections.
➢ The HEPA exhaust filter removes dirt
from recirculated air.
➢ Check filter when installing a new
dust bag.
Dust
Cover
➢ If dirty, remove filter from bottom of
Cubierta
de polvo the dust cover by pulling straight up
Couvercle
on retainers on frame. Lift one side at
a time.
➢ Place new filter in dust cover DO
NOT CLEAN WITH WATER*.
➢ Place filter in frame and install in
dust cover. For proper operation the
white side must face dust cover grill.
*Filter cannot be cleaned and should be
replaced at least once each year.
- 28 -