Bell CONSOLE 500 Mode D'emploi page 10

COMPUTER FUnCTiOnS
Clock (12H/24H): A 12 or 24-hour digital clock is displayed on the
third row of the screen. After Km/mile selection in setup mode,
the 12h/24h will flash. Press the RIGHT button to switch between
the 12 and 24-hour format.
Press the LEFT button to confirm and advance to the clock mode.
Press the RIGHT button to advance the hours (hold RIGHT button
for fast advance). Press the LEFT button to confirm hours. Press
the RIGHT button to advance minutes (hold RIGHT button for fast
advance). Press LEFT button to confirm minutes and advance to
"Maintenance Required Function".
Maintenance Required Function: On the top left hand side a
wrench icon will be displayed, just below the wrench the KM
(or miles — M) will be displayed and the top row digits will be
flashing. The digits represent the distance interval in KM (or miles)
that the wrench icon will start flashing to remind you to perform
maintenance on your bicycle. You can choose a maintenance
reminder for every 200, 400, 600 and 800 KM (or miles). If 600
KM is chosen, the wrench will flash every 600, 1200, 1800 KM (or
miles), etc. Press the LEFT button to stop the wrench (
flashing. Press LEFT button to confirm maintenance interval and
exit setup mode.
All manuals and user guides at all-guides.com
ODOMETER: To set the odometer
(ODO) after battery replacement
and wheel size setting, press RIGHT
button to advance to ODO mode
and then hold LEFT button for 5
seconds until the last digit of the
ODO is flashing. To adjust the value,
press the RIGHT button and then
press the LEFT button to confirm
and select the value. Repeat this
sequence to reach the desired
odometer value.
) from