Publicité
Les langues disponibles
Les langues disponibles
Ensure the fan is in the OFF position before plugging into a 120V/60Hz outlet.
This fan has a 4 position push-button control located at the front of the fan's upper column (#7):
[ 0 ]
[ 1 ]
[ 2 ]
[ 3 ]
This fan has 3 functions which will allow you to better customize your preferred air comfort as well as improve
the air circulation in the room:
OSCILLATION:
To activate the oscillation function for widespread breeze distribution, simply press the oscillation knob (#13)
down located on top of the fan's motor house. To turn off the oscillation function for a targeted breeze setting,
pull the oscillation knob up. Controlling the oscillation can be done while the fan is operating.
TILT:
To tilt the fan head so that the breeze is targeted at an angle, steady the motor housing of the fan with one
hand and grip the fan head with another, carefully tilt the head of the fan until it reaches the desired angle. This
position will hold. Be careful as to not tilt the head back further than it is intended to go, doing so will damage
the unit.
HEIGHT ADJUSTMENT:
To adjust the height of the fan, grip the extension column and loosen the height adjustment locking nut (#9).
Without completely removing it, extend or lower the column to increase or decrease the height of the fan. Once
the fan is at a comfortable height, tighten the locking nut to secure the column at this level.
CAUTION: TO PREVENT ELECTRICAL SHOCK, MATCH BLADE AND PRONG OF PLUG TO SLOTS IN
THE OUTLET, FULLY INSERT.
CAUTION: TO PREVENT ELECTRICAL SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
1. Always disconnect the cord from the electrical outlet when cleaning your fan.
2. Light accumulated dust may be removed by using a soft cloth to wipe away the dust at the back grille of the fan.
3. Wipe the exterior surfaces of the fan occasionally with a damp cloth (not dripping wet) and dry thoroughly with a soft
dry cloth before operating the fan.
4. Do not use harsh cleaners or materials to clean this unit, doing so will cause damages to it.
CAUTION: DO NOT ALLOW WATER TO RUN INTO THE INTERIOR OF THE FAN AS THIS COULD CREATE A FIRE
OR ELECTRIC SHOCK HAZARD. THE FAN MOTOR IS FACTORY LUBRICATED FOR LIFE AND WILL REQUIRE NO
FURTHER LUBRICATION. NO OTHER USER MAINTENANCE IS REQUIRED OR RECOMMENDED. IF SERVICE IS
REQUIRED, SEND YOUR FAN TO THE NEAREST SUPER ELECTRIC AUTHORIZED SERVICE DEPOT.
AIRWORKS
16MPWA
OPERATING INSTRUCTIONS
Pressing this button will power the fan OFF.
Pressing this button will power the fan ON at LOW speed setting.
Pressing this button will power the fan ON at MODERATE speed setting.
Pressing this button will power the fan ON at HIGH speed setting.
ITEM N
VOLTAGE (V)
CURRENT
CLEANING & MAINTENANCE
SPECIFICATIONS
O
16MPWA
120V AC, 60Hz
0.4A
4
Publicité
