Airworks 16MPWA Manuel D'utilisation page 3

1. Front grille
2. Plastic spinner
3. Fan blade
4. Plastic nut
5. Rear grille
6. Motor shaft
7. Control panel
8. Extension column
9. Height adjustment locking nut
10. Lower column
11. Cross leg base & end caps
12. Base cover
13. Oscillation knob
14. Motor housing
15. Upper column
FAN BASE AND COLUMNS ASSEMBLY (#8 through #15):
1. Take the two bars and fit by crossing together (#11).
2. Secure lower column (#10) and cross base (#11) with 4 provided screws. Slide down base cover (#12)
to conceal screws and place end caps onto each 4 ends of the cross base.
3. Pull out the extension column (#8) from inside the lower column (#10). Hold in place by tightening the
height adjustment locking nut (#9).
4. Secure the upper column (#15) on top of the extension column (#8) and tighten the knob.
GRILLE & BLADE ASSEMBLY (#1-#6):
5. Set the rear grille (#5) to the motor housing (#14) with the handle facing up.
6. Secure together by screwing the plastic nut (#4) clockwise onto the motor housing (#14).
7. Install the fan blade (#3) on the motor shaft (#6) with the cutouts on the blade fitted to the motor shaft.
8. Screw the plastic spinner (#2) on the motor shaft (#6) to hold the fan blade (#3) in place by rotating
counterclockwise.
9. Install the front grille (#1) onto the rear grille (#5). Be sure the clasps and hooks on the grilles are
aligned.
10. Close all the rim clasps to secure the grilles (#1 and #5).
AIRWORKS
16MPWA
PARTS OF THE FAN
ASSEMBLY
3